Search results

Considering adding the ScreenLogic2 interface to my Pentair automation system (purchase of 522104). I don’t own a Windows based PC, so won’t have a platform to load the provided software. I do have an iPhone and iPad. By downloading the ScreenLogic and SL Config app to one of these devices, will...

Our State-Rite SR400 gas heater shuts down when switched from Pool mode to Spa mode. Pool is 10 months old, and heater has worked fine in both Pool and Spa mode until yesterday. It still works fine in Pool mode, fires up when heat is called for, shuts down when set point is reached, etc. When...

We bought a newly constructed home with pool; we had no input on pool configuration, equipment, or setup. The current configuration has a manual bypass valve between pump and heater ("A" in attached pictures), and is set so that water is always running through the gas heater, regardless if the...

I hope this is an appropriate location for this question. A Paramount PV3 in-floor nozzle was stuck in the up position, so I used the Paramount tool to remove the nozzle. The PV3 came out but it dislodged itself from the bottom retaining collar, and the collarremains stuck in the in-floor...

Have a Pentair EasyTouch PSL4 with ScreenLogic. Want to install a Pentair IS4 Spa Side Remote. Connected the IS4 wiring to test operation; as soon as I put switched the breakers back on the air bubbler turned on and wouldn’t shut off. The IS4 buttons controlled nothing. The bubbler wouldn’t turn...

I’ve been suspect that our pool service isn’t doing a lot to earn their $100/month for weekly service, primarily based on the fact that they’re here 5 minutes tops! Supposed to check/adjust chemistry to keep water balanced, brush walls, clean filter cartridge monthly, and vacuum as needed...

New pool owner so I apologize in advance for using any wrong terminology. Pool was originally built about 20 years ago. Recently advised by our pool service company that we ought to replace our pump due to bearings going out (it was making a very loud whining kind of noise). Previous pump was...

Recently had an IntelliFlo VSF pump installed. I have a Pentair EasyTouch PSL4 w/ Screenlogic. Installer didn't seem to know a to about the screen logic interface but he did successfully get things connected. I noticed in the ScreenLogic Config app (on iPhone and also laptop version) when...

Brand new to pool ownership and have been doing a lot of reading and trying to get up to speed. That's how I came across this forum. Today our neighborhood had a power outage; power was out for about 15 minutes. When the power came back on it took a while for our systems to reset...

We purchased a home in 2020 in Naples, FL with an in-ground pool. The pool was originally built in 2002 and it was obvious the previous owner didn't take very good care of the pool aside from weekly maintenance/chemical balance service. It is a 15,000 gal standard chlorinated pool with spa (not...