Search results

I have an older Goldline Aquarite SWG which I know is now Hayward. It's running r1.4 firmware. I think I understand the cycle time on these is supposed to be 2 hours. What I'm not clear on (And I've done a lot of reading posts and info pages). If I have mine set to 100% and it runs for over...

My CH is currently 575. Pool Math suggests my upper target level is 550 and my max safe range is 650. I've seen it mentioned here that you don't have to worry about it until it hits 800. I found quite a bit of calcium build up in our SWG when I cleaned it recently. I was wondering if I even...

I have some algae showing up in our pool, so I want to slam it to get rid of it again. I have a quick question. What flow rate do I have to run it during the slam? The water is clear, but I have some deposits showing up in some shady areas.

We have a Rheem 337A Low NOX Model pool heater. When it tries to start it shows a CFH (Call for heat) then shows a "SPR" (Spare Fault code indicator). I can't find what that means. I just wanted to check here before I order a replacement board. I had already fixed some cold solder joints in...

We just had several Cypress trees removed from around our pool. They did a decent job, but during the process, they lost control of one of the big pieces they were going to lower via rope and dropped it on our pool side. It hit right at a grout joint and broke the corners off of two pieces. I...

After Hurricane Hillary came through we finally decided to remove the Italian Cypresses that we have around our pool. I've attached a before and after photo. I just wanted to be sure I'm going to be on the right path before when I start cleaning the pool when they are done. The pool was...

I'm looking for ideas on how I might be able to patch these without draining my pool. They are in the shallow end. I suspect they were originally caused by the kids using plastic oars while floating in the pool. They have slowly enlarged. Is there and underwater epoxy/plaster patch I can use...

Apparently my SWG has died. The display works and the flow led lights up, but now power led or generating led. My salt level is 3000 (display), 3200 per last test. The display readout as follows: 1: Temp 78 2: Cell voltage 12 3: Cell current 0 4: 95p 5: -0 6: AL-1 7: Firmware version 1.4...

I love the app. I was wondering if is there a way to add quarterly reminders for cleaning my SWG. I used the note function to add it to my log, but it would be nice if it was one of the built maintenance log functions :-).

I've always had an issue finding the link to my pool math logs from my profile like everybody said I should. So I put a link to access my logs in my signature. I also couldn't see the link from anybody else's profile. I usually use Chrome to peruse the internet and finally thought of pausing...

I have my pool looking better than it's ever looked after joining this web site, but I have a quick question. The inside of my pool vac is stained, I'm assuming it's from past algae build up. I've tried scrubbing it and soaking it in a bucket of bleach and water, but can't seem to get rid of...

This is a test to check out my signature.