Search results

I would like to install the cell then flow sensor inline where I have circled in red. Between the elbows is 19.5" of 1.5" pvc. I am reading the manual and it says the flow sensor is 4" and the cell is 15.75" - total of 19.75". Looks like I am just short, .25", to install it. Here's the...

I have a Jandy Laars LX 400k BTU heater that just died. It was installed in 2004. I was looking to replace it with the Raypak 406A equivalent but my pool guy is insisting that I go with the 336k BTU version because the supply gas line is a 5/8" diameter. Reading through the Jandy and Raypak...

Looking to get quotes to renovate the pool deck, coping, new autocover, liner, and cover box. Doing research now but thought I would see if any of you are in MN and had recommendations based on personal experience?

We opened our pool roughly a month ago. At that time, I tested and added chlorine and filled pool to normal operating level. For the next three weeks the temps in Minnesota swung back down to 30's/40's with occasional days into 50's/low 60's. The water temp was always well below 50 degrees so I...

We have been in our new home for a week and loving the pool. I noticed around the pool deck that none of the expansion or control joints in the concrete are caulked. Should they be caulked or is there a reason to leave them as is? We live in Minnesota.

Hello, been looking over this site for a few weeks before we closed on our new home with a pool this week. had a TF100 ready to go! Previous owner was using Clorox trichloro tabs in skimmers as well as shock, Algaecide, and “clear”. I am looking to switch everything to the TFP method. I...