Search results

Hey guys, taking another shot at this issue this spring. I'd like to program my system so that the heat pump only runs during the day, for increased efficiency. Pentair ultratemp, and easytouch 4. I do not have screenlogic. I'd rather not purchase it just for this purpose unless that's the...

m replacing the motor assembly in my prowler 920 after posting here and trouble shooting without luck. In researching I found threads asking about the difference between 920 and 930, non Bluetooth and Bluetooth enabled model. The motor assembly for 920 and 930 are the same. The control units...

Been searching internet and TFP. 2.5 years on robot, it spends most life underwater. Impellar seems to spin free and it churns water above on startup so I think that's good. The robot will move a foot or two, stop for ~10 seconds, move another foot or two, stop. After a few cycles of that it...

We have the pentair Ultratemp heat pump and Easytouch 4 for controller. I had been using the simple thermostat based control in the heater, but would like to limit the heater to run only during the day. As the PB didn't connect via rs485 during construction I'll do that. However, reading through...

We have a new pool with about 25 ft of the 42 ft length on one side as an infinity edge. Drop is 4 ft to the catch basin. We love the look, still trying to find best setup of drains, returns, skimmers. The main pool has two skimmers opposite the infinity edge, two main drains in deep end...

Hopefully my sig shows up. I need to go look up specifics of pump, filter, etc. Using TF-100 test kit and salt test kit from Taylor recommended here (1766 maybe?). Pool builder has been maintaining (?) chemicals after construction was finished late last year while working out a few kinks in...