Search results

I have recently installed a 16x36 steel walled pool and have an 89" round spa to install along the side. I have figured out the plumbing but unsure if the spa should be placed on a bed of sand or the 57 stone I used for the backfill of the pool. I have read about stone, over time pushing through...

I'm in the middle of a pool build and the builder I was using has disappeared. I need to get water moving & finish up some plumbing. Here is what has been completed: *Pool is in the ground with liner installed and water still below the skimmers. (No backfill in overdig but footer is poured) *All...

In the middle of a DIY vinyl pool and getting some help from a local pool builder & have a question about the plumbing he completed. He ran all plumbing in the bottom of the over-dig. My question is, why not run it at the height of the returns or bottom of shimmer? Basically, as soon as you...

Hello all, I'm preparing to build my own pool using a kit from Pool Warehouse & need input on pumps & how to plumb a system. My pool will be a 16x36 vinyl lined rectangle with full width steel steps. I will have an 89" round spill over spa made by Sunbelt. I have been told that I need a 1.5...

Hello everyone. learning a lot from the information on here but have a lot to learn. DIY pool project & would appreciate any advice or suggestions. I'm planning to install an 18x36 steel walled vinyl lined pool with a full width steel step and a Sunbelt brand 89” round spillover spa. Below...