Search results

Thank you pooldv. I have contacted two pool builders to get them to come out and check things. Unfortunately, I think I might be in a spot where the pool builders are not extremely knowledgeable only because the questions I've asked have not necessarily been answered in the manner or with the...

Thank you Razorhog. I finally got an electrician out to take a look and he definitely found some voltage issues; however, I am not sure how much I trust the information other than voltage occurring. I say that because when I got home after talking with him in the morning, I found a grounding...

I was reading the below post yesterday and thought my bonding could be bad; however, when I went back out to the pool after a few hours, I no longer felt that shock/sting on the open cuts/sores on my hands. What prompted me to search the threads is that I had just finished hosing off the...

Well, I know this is a bump on an old thread but I figured I would let everyone know what happened. I finally ended up opening the cover on the Jandy pump at the electrical housing and it was FILLED with water. I think the pool guys didn't seal it properly when they installed the SWCG which...

I went out to my pool and noticed that the pump was not running so I went over to the controller panel and noticed that it was turned off. I pressed the eStar button (RPM:1750) to get it going again and it said "PRIMING." Then it stopped and gave me a fault code of processor/software. I have...