Search results

Lights have not been working since new board and flow switch installed last week. Tech set one relay. Transformer is on a seperate relay. Added second relay in config and lights work. Cmon its not rocket science.

Mos def. Ran into a lady at wally world buying bleach Yesterday. She was pool stored and was about to buy the blue stuff. By the time we were done chatting she was heading home to slam with tfp page on her phone. 3rd one so far this summer. Drop it like its hot…

Cmon I am a run it hot guy like @Newdude lol. Nah just needed to test output after all the problems pool builder had getting this thing running. Will test tomorrow and see if the water I am adding dilutes it a bit. Tested tap water no measurable salt.

Still the same adding fresh water trying to dilute. Running pump on high try and mix a little faster. Will check in morning. Thinking of shutting swg down now that I know it will produce the chlorine I need. Plus sitting at 20 fc is unnecessary for our bather load. 😂

Ran test 3 times. 16 drops. May have had a smidge more than 10ml on first few salt tests recently. Made sure I was dead set 10 with teenage sons eyeballs.

Will redo again. Was not sure if I am supposed to use Swg or taylor test in poolmath.

Everything read clean. 240 where it was supposed to be 120 was right there. 12-13 on yellows ind and 24.95 combined. Can I wait a few days for the fresh water I just added to mix in before adding more or replacing. Any math on what I believe is a 12k not 13k pool for water replacement to lose...

I will check tomorrow and repost. Added 1300 g of water yesterday test came in at 3800 on taylor. Odd because I only added 240lbs of salt.Calculated it as a 10000g pool instead of the 13k so I would not overshoot. Added 4 tested at 2400 3 days in a row added 2 more and sitting at 3800. What...

Is my cell current above 8 due to high salt? Volt when off sits aroun

@JamesW just finished discussing this with wife as you post came in. 😂😂

Thank you to everyone for all your help throughout my build. I have been able to maintain a clean pool since May with only bleach and 4 lbs of baking soda. Chlorinator is finally up and running. Ran at 100% for 16 hrs and fc just came in plus 9 from yesterday even with the addition of nearly...

Ok tech swapped board still not reading flow. Could it be the sweep after the flow switch. Should I have them flip flop the chlorinator and flowswitch positions? @JamesW

So still no chlorinator bad Hayward board being shipped. 😡😡😡

Almost finished.