My Blue Essence salt system is not working correctly. When I power on the system,
Here are the readings:
0 Average Salt Level (Default LCD reading)
78 temp
15.2 cell voltage
0 cell amperage
53 P output %
-0 instant salt
AL-0 program code
1.55 circuit board revision
t-15 cell size
Actual salt is ~2800 (measured using test strips).
I have checked the 20amp fuse and it is good.
The flow sensor appears to be working properly.
The thermistor is visually OK and measures 15v on the near side and 22v on the far side
I am using a brand new T-CELL-15 from Hayward that I just installed.
I do not hear a relay "click" during startup.
On startup the No Flow light flashes red for 60 seconds.
Then the Generating light turns green for 10 seconds.
Then the Generating light turns off and all LEDs remain off, even if I switch between Off/Auto/Super Chlorinate.
The diagnostic button allows me to switch between the LCD readings and make adjustments.
The readings above are the same during 60 second startup and during the 10 second Generating (no differences)
Main Board is Goldline Controls (C) 2009 G1-066012E-1
Display board is Goldline Controls (C) 2008 G1-066604G-1
Thanks!
Here are the readings:
0 Average Salt Level (Default LCD reading)
78 temp
15.2 cell voltage
0 cell amperage
53 P output %
-0 instant salt
AL-0 program code
1.55 circuit board revision
t-15 cell size
Actual salt is ~2800 (measured using test strips).
I have checked the 20amp fuse and it is good.
The flow sensor appears to be working properly.
The thermistor is visually OK and measures 15v on the near side and 22v on the far side
I am using a brand new T-CELL-15 from Hayward that I just installed.
I do not hear a relay "click" during startup.
On startup the No Flow light flashes red for 60 seconds.
Then the Generating light turns green for 10 seconds.
Then the Generating light turns off and all LEDs remain off, even if I switch between Off/Auto/Super Chlorinate.
The diagnostic button allows me to switch between the LCD readings and make adjustments.
The readings above are the same during 60 second startup and during the 10 second Generating (no differences)
Main Board is Goldline Controls (C) 2009 G1-066012E-1
Display board is Goldline Controls (C) 2008 G1-066604G-1
Thanks!
Last edited:
