How to repair loose safety cover anchor?

Jump to latest Follow Reply
Saturn94

Saturn94

Bronze Supporter
Mar 11, 2015
1,760
SE Virginia
Pool Size
20000
Surface
Vinyl
Chlorine
Salt Water Generator
SWG Type
Hayward Aqua Rite (T-15)
Where did summer go? I can’t believe it’s already time to prep for closing. ☹️

We have a safety cover anchor that has come loose (can spin it around in the concrete deck/lift it out). I’m thinking of using some kind of epoxy to stabilize it? What would be best to use?

I actually discovered the loose anchor last fall, but it still functioned fine so I didn’t bother with it then. 😊
 
Last edited:
They are fine when they spin, so long as you can adjust the head. I'd pull mine out, hold the tube firm to adjust the nut, then pop the tube back in.

They need zero vertical strength. It's 100% horizontal force and the deck isn't moving one bit.
 
  • Like
Reactions: Saturn94
Newdude said:
They are fine when they spin, so long as you can adjust the head. I'd pull mine out, hold the tube firm to adjust the nut, then pop the tube back in.

They need zero vertical strength. It's 100% horizontal force and the deck isn't moving one bit.
Click to expand...

I wondered about that. It held fine over last winter.

1poolman1 said:
How large is the hole it is in? You can get anchoring epoxy at Home Depot for about $25.00 a tube. As Newdude mentioned, it may not be needed if the anchor itself stays in its socket, it is a horizontal load.
Click to expand...

I guess the hole is about 3/4” - 1”? There is no apparent damage to the hole or the anchor. Here’s a pic
63F9975D-A988-408D-845E-F2BD5227F8AA.jpeg

So, just leave it alone?
 
Last edited:
1poolman1 said:
You could try this, the tubes at Home Depot would be a large waste of material (found on Amazon but may be available at a Home Depot):

PC Products 70086 PC-Concrete Two-Part Epoxy Adhesive Paste for Anchoring and Crack Repair, 1.4 oz in Applicator Syringe, Gray​

Click to expand...

Thanks for that suggestion. I see it’s available at our local Ace Hardware for about $7.
 
  • Like
Reactions: Saturn94
Newdude said:
@1poolman1. Any thoughts about a construction adhesive? Most are available in small tubes which would make them reusable when a mug breaks.

PL, liquid nails, etc.

​

Click to expand...
Might work if the label says it is suitable for a wet environment. Like concrete, epoxies tend to swell slightly as they cure, locking the anchor in place beyond their adhesive qualities. That's why they are good for this type of application. The PC Products listed is made for this specific application, is inexpensive, but other types like you show may work as well. I've not used it, but have used other brands to anchor pool equipment on the very rare times I've done so.
 
  • Like
Reactions: Newdude and Saturn94

Enjoying this content?

Support TFP with a donation.

Give Support
You must log in or register to reply here.
Top Bottom
Back
Jump to latest Follow Reply