- May 9, 2021
- 140
- Pool Size
- 19300
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Something stuck in Check Valve.. O ring?
- Thread starter thegizzard
- Start date
- May 9, 2021
- 140
- Pool Size
- 19300
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Can you advise how to open that? Filter off. Service Mode. But I could not twist off the cover. Are there screws?
It should just unscrew.
Close the suction valves and open the pump lid to release the pressure.
Close the suction valves and open the pump lid to release the pressure.
- May 9, 2021
- 140
- Pool Size
- 19300
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Ok got it. The Jandy actuator was blocking the cover from unscrewing all the way off. I had to loosen the actuator to twist off the cover nut.
I pulled out what looks like a slice of PVC. I assume this does not belong in the plumbing.
I pulled out what looks like a slice of PVC. I assume this does not belong in the plumbing.
Attachments
It this a new pool, or recently re-plumbed? That looks like a bit some plumber carelessly let get into the plumbing after he cut it off to make the pipe he was working on fit properly.
- May 9, 2021
- 140
- Pool Size
- 19300
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
New pool. Finished and Filled in November. I sent the pics to my PB and he agreed it was trash. I guess I just learned something about my pool. I would not have thought to check the check valve for debris.
Similar threads
