Blank canvas in Laughlin, NV.
- Thread starter akageorgi
- Start date
BigPapaSmurf
Well-known member
Hmmmm, looks like the standard sitting on the edge, dangling my feet in the water, block! 
Not much to update. Nobody wants to work, supplies are backordered, temperatures are hot- everyday...
Was going to do concrete table by pool barstools. Then it was a stone slab, after running into dead end after dead end, I decided to build the table out of my leftover travertine.
Cinder blocks from previous image are to raise the outside seating table up...
kinda sorta maybe like this:
Was going to do concrete table by pool barstools. Then it was a stone slab, after running into dead end after dead end, I decided to build the table out of my leftover travertine.
Cinder blocks from previous image are to raise the outside seating table up...
kinda sorta maybe like this:
This pebble border will eventually go around entire pool, this section is my test area...hehe
Don't think it looks too bad.
Ok for someone who, well you know...
Don't think it looks too bad.
Ok for someone who, well you know...
BigPapaSmurf
Well-known member
So, throughout this entire saga I have been a fairly happy go lucky kinda guy.
But here comes some meanness...
I
TRULY
HATE
THIS
ROCK
END TRANSMISSION...
But here comes some meanness...
I
TRULY
HATE
THIS
ROCK
END TRANSMISSION...
Man oh man I am glad I am NOT that rock!!! Can't wait for the full story on what this rock did to upset you so!!
BigPapaSmurf
Well-known member
RoyR
Bronze Supporter
Turn it 90 degrees clockwise and use it to display your backyard name….or, take a hammer and beat the |…\^[]< out of it.
Had a little drainage issue when it "monsooned" us a few weeks back.
Should be all better now...
Anyway, should be posting some more soon...
Should be all better now...
Anyway, should be posting some more soon...
If it is not one thing it is another! That is a LOT of water right there! Looking forward to more progress posts and pictures!
- May 3, 2014
- 58,603
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
It was only about a half inch in less than an hour. May get more next week.
I was going to have the concrete guys pour a pad for a future bbq island at the same time they did the deck. So in the same fashion as the last 4 years, 
I decided to do it myself.
Here are some pix in chronological order for your viewing pleasure...
...and leftover travertine put to good use...
Still have to fine tune some stuff, but a we're a little closer to completion than we were yesterday...
I decided to do it myself.Here are some pix in chronological order for your viewing pleasure...
...and leftover travertine put to good use...
Still have to fine tune some stuff, but a we're a little closer to completion than we were yesterday...
Last edited:
Latest pool update:
Well, after dodging a hurricane in Cabo last week I'm back at pool building...
I have a deadline now.
Will have some Earth-shattering updates in the next week...
Well, after dodging a hurricane in Cabo last week I'm back at pool building...
I have a deadline now.
Will have some Earth-shattering updates in the next week...
SOMEBODY WORKED IN MY BACKYARD TODAY! SOMEBODY THAT WASN'T ME. 
RUMOR HAS IT THAT SAID SOMEBODY WILL DO IT AGAIN TOMORROW!!!
Hopefully I'll have some meaningful pictures to share later this week!
RUMOR HAS IT THAT SAID SOMEBODY WILL DO IT AGAIN TOMORROW!!!
Hopefully I'll have some meaningful pictures to share later this week!