I have the Raypak R4350TI-E, and I noticed a some water under it yesterday. I’m not running the heater, so I know it’s not condensation. I’be circled the area where it is leaking, and my question is can I just try to tighten that adapter? Since it is hooked up to the copper I wasn’t sure if I could tighten a bit, or would that loosen the copper connection somehow and I lose my refrigerant? Thanks in advance!
Heat Pump Leak Repair
- Thread starter black98gti
- Start date
- Jul 21, 2013
- 66,209
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
It goes directly to the compressor. I ended up tightening the pvc part a tiny bit, and so far, it isn’t leaking anymore.