Wiring Cover Suggestions?

Jump to latest Follow Reply
jbird0215

jbird0215

Gold Supporter
Feb 1, 2020
108
Nashville, TN
Pool Size
24000
Surface
Vinyl
Chlorine
Salt Water Generator
SWG Type
Hayward Aqua Rite Pro (T-15)
Hello, what would you suggest I do with these exposed wires feeding my pump? I’d prefer to not have to remove the wires and feed them through another wire cover but will do what is necessary to ensure safety/minimize wear and tear. Thanks.
1607197051953.jpeg
 
215,

There is really only one way to fix it and you already know it... :mrgreen:

I can't see the whole thing, but does the flex conduit have a big droop in it that can be taken out so that you can reconnect the end back into the connector at the pump end? You might have to support the cable better..

Thanks,

Jim R.
 
Thanks ajw and Jim R. Wiring goes to the ProLogic panel, which I became very familiar with today. I removed 2 pumps from the setup that were plumbed incorrectly and no longer needed. Both had covers that I could repurpose for this pump. I just didn’t want to unhook the wires if there was a simpler fix.
 
8CCA14E6-06B3-4E59-9C98-A395140DDC55.jpeg
unscrew the end of the connector the arrow is pointing to, then shove the liquid tight back into the connector & screw the end of the connector back on. It just came loose from the fitting . Maybe it wasn’t tight enough & someone tripped over it.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply