I'm Joe and this winter I'm going to be DIY resurfacing pool. Its been repaired several times with aquatic fiberglass matt and resin and lining is pulling away from wall. (1/2 side of deep end).
Hey Joey and Welcome !! I haven't spoke to anybody else about it but let me just speak for them anyway. We are going to LOVE LOVE LOVE to follow you on your journey. Thanks for finding us. Thanks for joining. Thanks in advance for all the pics and progress you'll post. Oh, yeah..... and we have lots of folks who can help with ideas and procedures.
When you get done with your pool can you make a housecall to @dianedebuda ? It looks like you have similar fiberglass pools with problems. Anything you can share about repairs on her thread would be appreciated.
I'm Joe and this winter I'm going to be DIY resurfacing pool. Its been repaired several times with aquatic fiberglass matt and resin and lining is pulling away from wall. (1/2 side of deep end).
Ok. so i get the pool drained and start to remove the fiberglass, when i get to bottom drain i find it full of sand, and no piping. plus it wasnt sealed to the plaster. so water would seep between plaster and fiberglass. Now im no expert but there is supposed to be a 2-3"(guessing) in pipe going to the filter correct? i dont know why 75feet is poping in my head, could it be the length to filter?
With an air chisel, i chiseled out the center of the missing bottom drain. well i had picture but to big to uplaod. anyways i found the bottom pipeing. as soon as i busted through almost 4 inches of plaster, dirty brown water came out. so now have to see condition of pipe to filter.
I've also got a question, once i remove fiberglass lining and expose the plaster underneath cant i wash it with tsp, etch it with 50/50 muriatic acid and water, power wash agaimn and use something like Dura-Rubber instead of breaking out all the old plaster to gunite and replastering? HUGE price difference
After reading documentation and instructions i cant see any reason i couldnt. But im far from an expert so i may have misunderstood. If i could get some clarification please
so ive almost got all the fiberglass removed. most of it wasnt stuck to plaster. there also a few hollow sounding spots of plaster i must chisel into till sounds solid.
well it turns out that under the fiberglass is plaster, of course thats what i was expecting; however under the plaster isnt gunite like i was expecting but another layer of plaster. I havent stated to air chisel it out yet, still trying to determine why
Probably been replastered with a 2nd coat. Not to discourage you but there is nothing DIY that holds up for a finish other than plaster. If you wanna do this once amd be done for 15yrs+ chip it all out to the shell and get a pro to smack out a basic white plaster job. Will be cheap with it prepped. Imagine dealing with this labor again in a few years and having spent money on material too. My honest advice to anyone in this boat
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!