New Radiant Metric 16*32 oval installation

Jump to latest Follow Reply
Egghead2004

Egghead2004

0
Silver Supporter
May 5, 2015
83
Charlton, MA
We pulled the trigger and bought a Radiant Metric 16*32 oval.
I plan on documenting the entire project here as there isn't a lot of real detail online regarding these pools.
There are a few posts of these installs on this site that are very helpful, but most are of the round metric pools and some details that I was searching for were not available.
I plan on sinking the pool down about 2 feet and build a stone patio around it.

This is the yard last year

back yard grass.jpg

Same view after hole and trenches.

IMG_4175.jpg
 
Thanks! That yard was a few years ago when the lawn was looking real good.
I do have a question about the stairs to wall mounting.

I leveled the stairs based on the top rim around the steps. The problem I am running into is that the sides where I bolted the wall mounts to is leaning forward about an inch into the pool area. This is causing my level walls not to align.

I see 3 options, please give me your thoughts on the best practice.

1. Remove some sand from the back legs of the steps so they unit will be tilted back about an inch, but the mounts will align to the level walls.
2. Adjust the wall mounts on the stairs so they are level with the wall. If I do this the wall mounts will set back about an inch from the face of the steps at the top, while still flush at the bottom.
3. A little of each. Drop the back of the steps 1/2" and tilt the wall mounts back 1/2".

If you need pics I can provide.

Thanks
 
Well, I went with option 1. The stairs are slightly tilted back. I found a couple pictures and a video online that showed the seam connector almost flush with the front of the stair flange. The diagram in the manual also shows this.

All walls are up with the exception of the one corner where we will truck the sand in.

Sure wish I could add some pics.
 
jpelizza,

Yes, I will be putting a full collar around the pool. I plan to have the pool about 52" deep except within 12" from the wall, there will be a quick 3" drop. That means I cannot use the wall ties, so a collar is a must.
 

Enjoying this content?

Support TFP with a donation.

Give Support
Here are a couple of pics. This is just prior to mounting the stairs.
Now I am waiting for the rain to stop so I can bring in the 4 yards of masonry sand.

IMG_4188 (800x600).jpg
 

Attachments

  • IMG_4186.jpg
    IMG_4186.jpg
    64.9 KB · Views: 547
  • Pool steps (672x714).jpg
    Pool steps (672x714).jpg
    56.6 KB · Views: 549
The collar has been poured, now into the lights, returns, and liner
f1f98c45dcdd8c6d1ca78be274d4daf8.jpg



Sent from my iPhone using Tapatalk
 
This is a nice pool. Can't wait to see more progress!
 

Enjoying this content?

Support TFP with a donation.

Give Support
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply