Recent content by y2kdread

LOL - this is just based off me attempting to figure out the optimal schedule for turning over the water 2x in a day (I think). I used my FlowVis flow meter to determine the GPM and based it all on that. I did lose my spreadsheet where I did my calculations, so I don't remember the exacts. Is...

Hi Jim - I had a hunch that something was configured wrong, the pool builder didn't do a great job with the startup side of things after the pool was built. Here is my configuration. Just to note the "low" circuit is my main pool circuit. Schedule: On the two entries for the low circuit, I...

Hi Everyone - I am new to pool owning life and had some questions about the ScreenLogic automations and issues with the functionality. Pool Heater: I am in Texas, and it is that time of year where I can run the heater for a few hours to get the pool to a nice temperature. I can get it to run...

Hi Everyone - I have a new pool and we are hitting our first spring here in North Texas. One of our oak trees has been dropping a lot of pollen onto the deck and pool and we've noticed that it's been staining the decking. I took out our small electric pressures washer which is 1,200 PSI to...

will do, thanks!

Hi All, I was wondering if there was any guidance as to how many RPM I should set my IntelliFlow VSF pump should be set to when running a pressure side cleaner? The Builder set it at 3,400 RPM, but I think they just took the defaults for everything. Thanks!

Hi Everyone! I am a first-time pool owner and our pool is about 90% complete, we are just waiting on spray decking. I have noticed some things that look like they may be problems but want to double check with the experts. Our "pool school" was a joke, so TFP has been instrumental in learning...

Thanks for the welcome! Would you consider the plaster dust cleaned up when the water is clear or would it be after that initial week of brushing?