Recent content by Xenor

Well, I re-seated each lead. I cleaned the end of each wire with sandpaper and retightened the connector for each lead. I did this on both ends. There was also an open port on the mux and I switched it over to that. Same thing. Beep every few seconds, double been every once and a...

Forgive me, I might need some dumbing down but I think I got it. Looks like of the two rs485 ports on the top left of the main board, both have something plugged in. The one on the left goes to the ("mux" is for that multiplexer): I guess the one on the right is for the variable speed pump...

Ok, just reseated the cable. One end is plugged into the RS board, the other into a multiplex board on the side. I unplugged each and plugged it back in. Same behavior. Single beep with a very quick flash of 00%, occasionally it's a double beep with the same. Same error in iAquaLink...

Greeting, first post here. What do you know, it's a problem with pool equipment! I have a Jandy RS6 and a Zodiac Nature2/Aquapure system. All has been fine until today. Today the unit's control panel is beeping once every few seconds and occasionally twice. The unit shows up *sometimes*...