Recent content by whitehaireddude
-
W
How to Tell if RS485 is working from the pump - nodejs-Poolcontroller
Both on the same device. I got the same result when I started them manually with npm start& as I did when using pm2. However I have now pulled my Raspberry Pi 3 B+ from its other duties, started with a new microSD card and have installed from scratch on it and things look much more promising. I...- whitehaireddude
- Post #8
- Forum: Everything Else
-
W
How to Tell if RS485 is working from the pump - nodejs-Poolcontroller
Well I think I'll try installing on a real Raspberry Pi 3 tomorrow as following the instructions but running Raspian on a Libre.computer Le Potato, all I can see from Dashpanel is the following as well as no way to configure it.- whitehaireddude
- Post #6
- Forum: Everything Else
-
1680316185505.png
- whitehaireddude
- Media item
- Comments: 0
- Category: Pool Equipment
-
W
How to Tell if RS485 is working from the pump - nodejs-Poolcontroller
I tested and got continuity with the wires. Then just to make sure I didn't do something wrong in the setup since I had used Ubuntu instead of Raspian the first go around, I restarted all over with Installing Raspian. After I start nodejs-PoolController I see a number of these logged to the...- whitehaireddude
- Post #4
- Forum: Everything Else
-
W
How to Tell if RS485 is working from the pump - nodejs-Poolcontroller
OK I have a 10 year old Sta-Rite Intelliflo (rebadged Pentair variable speed pool pump) that I would like to connect to a nodejs-Poolcontroller. Since I can't get hold of a reasonably priced RPi, I am using a similar device Le Potato. The software installed no problem, I connected an Industrial...- whitehaireddude
- Thread
- Replies: 8
- Forum: Everything Else