wgipe's latest activity
-
Perfect, thanks all! -
wgipe reacted to Newdude's post in the thread Just got my TFP Test Kit - CYA Mixing Bottle with
Like.
You have to cut the tip. I use a sheetrock knife at a 45 degree angle. I cut a few small shavings until I reach the opening. It... -
wgipe replied to the thread Just got my TFP Test Kit - CYA Mixing Bottle.I also had to cut the tip off the top after removing the red cap. The size of the hole isn't super important. You'll put the cap on to...
-
wgipe replied to the thread Wanted: Dolphin Active30 Weight.It's pathetic, really, for what is clearly a manufacturer defect. I take the thing out of the water every single time after it runs...
-
wgipe replied to the thread Wanted: Dolphin Active30 Weight.I called Maytronics, and they were absolutely no help and downright dismissive - could not have cared less. Found the part (called a...
-
Any chance someone would has a dead Dolphin robot laying around that could sacrifice a side weight? I noticed in pulling mine out the...
-
-
-
-
-
wgipe replied to the thread Intellicenter i5P died.Just talked to Pentair. They are sending a replacement board no questions asked, and I don't need to send the old board back. I'd be...
-
All you have to see is if the display lights and the CPU boots and puts anything on the display. I have an indoor control panel (ICP)...
-
wgipe replied to the thread Intellicenter i5P died.You make a good point. At some point, it's just the cost of doing business and you go on with life. Protecting the most vulnerable...
-
wgipe replied to the thread Intellicenter i5P died.https://www.ebay.com/itm/392867711625?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=TgL5UY28RLi&sssrc=4429486&ssuid=heOsTm95Tnm&var=&wid...
-
Yup, have a Siemens FS140 surge suppressor hanging off the bottom of the panel. I don't think the damage was from the electrical service...
-
wgipe replied to the thread Intellicenter i5P died.Sounds like the same deal. Out of curiosity, do you have a surge suppressor on your panel? I didn't have room for one, and now I'm...
