Recent content by wfgworks

I'm assuming you have the Tristar 3202VSP Model? There are a few different models out there. Certain models of the Tristar can be connected without any adjustments but a few models require adjustments for the Omnilogic to recognize it. 1. Make sure your software is up to date on the...

I have an Omnilogic to control my pool equipment. One thing I haven't figured out and I'm sure it's an easy fix, is every time I use the heater for either my pool or spa and the water reaches the desired temp, the Omnilogic always defaults to the LOW speed setting for my pump. I have a Salt...

I'm not sure. The previous home owner had the pool renovated 5 years before we bought it. What kind of sealer should I be using around the pool area?

I switched over to salt last year and was wondering if I should be sealing the stone around my pool. Let me know your thoughts as I've attached a photo of the stone I'm referring too.

Can someone post a picture of your schedule for your VSP pump on the Omnilogic? I'm looking to have my pump run at different speeds throughout the day and I must have the programming wrong as the pump turned off when switching schedules and never went to the next schedule. Thank You

I haven't tried that since I was only trying to get the pump hooked up through the Omnilogic which involves disabling the display. The only thing I noticed was the instructions mentioned adding a third wire for improved communication. I may try that tomorrow. I didn't know if I was missing...

Brand new pump just installed today.

So I've tried for over 2 hours with no luck. I think I followed all the steps but I'm new to owning a pool. Any help would be much appreciated. Steps I've taken 1. Power wires from pump connected directly to the breakers 2. Disabled the display panel on the pump by unplugging the terminal...

I talked myself out of the EcoStar as it just seems like too much pump and the local hayward guy said my plumbing may not like the EcoStar since my pool is 20+ years old with 1.5" plumbing.

Thanks Mark. Can I get the SP3202VSP and just disable the screen? I was hoping to have the display just in case the Omnilogic ever went down? I read through the SP3202VSP manual and it talks about disabling the screen for automation. - - - Updated - - - Page 17...

Does the Hayward TriStar SP3202VSP work with the Omnilogic or do I have to get the TriStar SP3202VSPND? Thanks!

Ok. I was going by the nozzles that's can be directed for water flow

Spa has 6 jets and they look to be 1/2" Pool has 2 jets and they too look to be 1/2" I'll measure when I get home. But they are not 1/4"

I'm thinking of getting the Hayward Ecostar but have read a ton of negative reviews about the motor failing? Has this been corrected or are people still dealing with that issue?