Recent content by visitor

This doesn't directly answer your question, but overall placement perimeter is shown here:

lined it up today & appears they're close enough to go ahead tear the Intex down, relevel/set ground/pavers, replace some rusted frame pieces & install a SummerWaves liner. Didn't expect this with the water drained, but i guess the adhesion of the liner to the frame is keeping it standing. :D

It's advertised w/$150 shipping charge & "30 day returns. Buyer pays for return shipping", so i'm not going down that rabbithole :sneaky:

Will a Summer Waves 24x12 liner fit directly on/in an Intex UltraFrame 24x12 frame? Do the holes in the liner that accommodate the frame structure match/lineup with the same in the 2 brands? :unsure:

Yes, we could do piping mods, but my question is regarding how close that return port in the pool side is to the skimmer. If i have to cut different holes & close/patch the existing ones it's not worth choosing the Summer Waves pool over an Intex, which by design had the return several feet...

We're considering replacing our 10 yr old Intex 24x12 and like the aesthetics of the Summer Waves rattan weave liner. I can adapt the skimmer to use our stronger Intex pump, but wouldn't the proximity of the inlet & outlet through the liner: make for ineffective circulation of the water...

As it sits, the relays from CL+ & CL- both have continuity to the throws that are soldered on the back side of the board to a bar that connects them both to GND , so i don't know that what i called a "short" isn't normal for this setup, just the relays in their rest status. :unsure: Whatever is...

From CNY, thanks to all for all your interest, sharing & help. Great forum! :cool:

We're getting the red service light on an Intex 26679EG combo pump/SWG when the chlorinator is activated. The pump runs fine and we have our old independent SWG temporarily running after the pump, but would prefer to have the combo unit working as it should. So far, the rectifier reads good and...