Recent content by Tkt2k

Thanks, I am using a seko pump model PPE000HA6001 its a fixed low speed low flow peristaltic pump (2.5GPD) it is connected to a hayward relay HLH485RELAY controlled by the omnihub I read the Sense and Dispense and omni manuals but could not find any reference to interlocks with the SWG.. I...

Is there a way to create an interlock within the OmniHub to prevent the acid pump from injecting acid while the AquaRite is on? Under the "Equipment to Equipment" settings, I don’t see the SWG listed at all. when the OmniLogic is configured to automatically dispense acid based on the pH sensor...

Great Info, thanks!

In case someone else uses a Pharmed BPT (TPE) tubbing .... Pharmed said Glycerine based (USP Grade) lubricant is the one needed for that particular model..... Seko said they don't use that kind of tubing in their pumps ( the reseller SOLAXX replaced it with a pharmed )

Thank you for the feedback!

Hello, could anyone please advise on a good lubricant for a peristaltic pump hose (the one between the rollers) ? I am using a Seko pump with a Pharmed BPT (TPE) hose for acid injection. I've seen conflicting information online: some sites mention not to use silicon-based lubricants, some say...

Thanks for looking into it, yes my AQR model can be configured as slave via jumper but then there is a communication error on the omnihub. it appears the AQR needs to be primary to use the daugther card to talk to the omnihub.... I called Hayward and told me I need two flow switches, one of...

Hello, I recently installed a Sense and Dispense (S&D) kit (for monitoring only; I do not plan to use it to dispense chemicals) with an AquaRite W3AQR3 (T9) connected to an OmniHub. The OmniHub documentation states that the flow switch should be connected directly to the AquaRite (a post back...

My Hayward VSP pump worked fine for 4 yrs then one day last year, it started making noises and after a few minutes it stopped and appeared to be seized... the driver showed " check motor and wet end for binding " I opened the motor and found the internal magnets in pieces causing the lock...