Recent content by timmypop

Any suggestions on where to have a leak company check? In the past they have done pressure testing and stated no leak. I have to add about 400# of salt every few months due to loss.

For years I have been chasing a leak. I have had two companies that can't find it. After a few years it is worse. I seem to have narrowed it down to an interesting phenomenon. I have an in ground with an attached spa. I have recently noticed the spa losing water. The strange part is, it looses...

My cheap Sandshark cleaner died after about six years and I used this forum to help me choose my next purchase. I picked up an Active 30i from a recommended dealer based on the posts from this site. I have used the Active 30 for two weeks and I have got to say this is the most disappointing. I...

I will say that the Android version is terrible. Every time I open my app and the pump is running, it will shut everything off for about five seconds ands then spin it back up. It does not do that on ios. I have uninstalled and reinstalled it multiple times.

Thanks all for the advice. I disconnected the bus and restarted everything. Had some intermittent success then quit. I swapped comm ports and restarted again. Seemed to fix but my lights then would not change. I had to delete and reconfig all of my lights in my ScreenLogic settings. three hours...

Thanks.

Had warranty service on my Globrite. After they left I noticed that I could not control my color change. My communication seems half working because I can connect via Screenlogic, turn on the lights, heater, etc. Started troubleshooting and realized my Intelliflo was not on the system. It does...

Contacted a friend who has Android and he said the same thing happens on his system. Sitting in the spa with therapies running, open SL to make temp adjustment and everything turns off for 10 seconds. Or having a party and water features running, open SL to make light change and system shuts...

Issue: If my pumps are running and I open Screenlogic on my Android, my pump shuts off for about 10 seconds, then resumes normal operation. When I do the same thing with ScreenLogic on my Apple device or computer I have no such problem. I spoke with Pentiar tech support and they said my configs...