Recent content by timd

No, the one in the picture is the only one I have.

One more question, do I need to change the jumper to make this Controller 2, like in the diagram below:

@dfwnoob - Thanks for the helpful information! I was able to find the wires and reconnected to one of the RS-485 data links on the new board, and the All-Button appears to be alive again!

So this wire was left inside the box, would it be as simple as plugging it into the board on the empty pins?

This is my Aqualink RS4.

Just had my salt system upgraded to a PLC1400 and upgraded to iAqualink3.0 Upgrade Kit w/ RS-PS8 PCB. We've always had the Aqualink RS4 mounted on the wall inside the house inside the back door, to control the pool, hot tub, and monitor the system (would display the air temp, water temp, salt...

Well... Soldered the new thermistor onto the board and same errors... Will search for replacement boards.

Moved from HERE I have the same similar issue with my T-15 cell. My Aqua Rite also does not display the cell type in the display, but I am on version 1.10 and it is configured with a jumper on the board. I purchased a new cell (Hayward T-15) yesterday, but my Low Salt and Inspect Cell are...

Yes, it might be a little cloudy but I filled it all the way to the top and could still see the black dot. Thinking I will wait till after my SLAM is over and test again before adding stabilizer.