Recent content by Thelama

  1. T

    Worried about bad workmanship

    Yeah the pad is quite small given it has a heater / sand filter / pump on it. They did remove the small privacy fence ( which just hides the equipment) when they were working on it. But they didn't mention any options about extending the fencing to improve the plumbing. will take a picture of...
  2. T

    Worried about bad workmanship

    Thanks for the info - must admit I have read that thread like a hundred times haha. I trucked in water to the cost of $1400 (ouch). I is another reason I am annoyed by my pool guy as he was still working on the plumbing etc AFTER he organized the water delivery, however he failed to tell me...
  3. T

    Worried about bad workmanship

    Thanks for the reply and the link to the manuals - the builder didn't give me the manual. I actually have a whisperflo - but it looks like a similar guidance - 10" before the front of the pump and specifically don't use a 90degree directly into the pump. did you see the first picture named...
  4. T

    Worried about bad workmanship

    Hey guys, I just had my pool replumbed (both underground and above ground pipes). Half way through i got a load of warning signs from my builder (slow build + trying to rip me off on parts pricing). I'm now concerned that he hasn't done a good job. So hopefully you can help. Firstly my pipes...
  5. T

    Need help, am I just being impatient?

    Seems like I'm talking in a vacuum... I have a question, I'm wondering if the green could be iron? Is it worth getting a filter and putting it in the skimmer? any recommendations for the filters? thanks.
  6. T

    Need help, am I just being impatient?

    Ok so I put 1.5 cups of DE in the filter to raise 1psi and repeated every hour (after backwashing). A few times I could see a load of green in the viewing capsule, so that's good. Kept it at 20FC (35CYA) so still a little high, but I'm paranoid. today pool looks similar, maybe a little whiter...
  7. T

    4 week SLAM Question

    Well done! I've just gone through the first week of SLAM, and I'm not really huge gains. So I feel your frustration. did you end up adding any flock / magic potion. I know it's not really advised but the family is obviously just as frustrated, especially as it's a new pool and we had crystal...
  8. T

    When to slam (or not too)

    Thanks guys
  9. T

    When to slam (or not too)

    Kind of a beginner question, but the tfp rules specify that you should not need to slam your pool unless the FC goes to 0 or cc is greater than 0.5 or you have algae. So if I maintain my pool at the recommended FC and a load of people come over and swim in it, I should just test it once they...
  10. T

    End of my rope

    Dude I feel your pain, same battles with the OH :( mines (pool not wife) been 4 days doing the SLAM. So set some realistic expectations!
  11. T

    Need help, am I just being impatient?

    Also put in a signature. also just as an FYI, I'm not losing a lot of FC per night around 0.5-1 per night / day. Not sure if that worries me or not given it's still green haha.
  12. T

    Need help, am I just being impatient?

    Ah ok, I just meant it wasn't like a swamp over winter with leaves and all that gunk. ive read the Slam guide like a thousand times over the last year and used it at the tail end of last season (though the high cya was a problem due to my dumb new-pool-owner ways). i just put in 1.5 cups of DE...
  13. T

    Need help, am I just being impatient?

    Ok so basically I'm being impatient right. 4 days of green is acceptable for a non-swamp algae bloom?
  14. T

    Need help, am I just being impatient?

    Ok, I upped the chlorine to 20ppm as I was angry this morning. Just wondering if I could put some flock in it to speed it up . I have a sand filter. S200 Hayward.
  15. T

    Need help, am I just being impatient?

    Thanks! I have one of the recommended kits K2006 or something. Also been double checking it by taking Water to the local pool store. Readings are almost identical.