Recent content by Tharber10

The Intelibright. BOth went out within a few weeks of each other.

Sorry for the late reply. I just fijnished the project today. I purchased a motor from Amazon for $128 1/2 hp 1075 RPM 48 Frame 208-230V 5 5/8" Diameter Condenser Fan Motor | EM3730F It worked like a champ but the condenser fan grille was also rotted out so I ended up buying 2 6" aluminum...

Thanks for the replies. Unfortunately all the motor labels are inlegiable. I had found the same parts and the $140 motor was ordered from allwatermeters only for them to cancel the order stating that there was a huge price increase. I'm going to order a non AquaCal motor from Amazon, so thank...

I have searched the internet for days without success. I have an AqualCal heat pump pool heater and the condenset fan motor shaft literally rusted in half. I know the motor part # is ECS0120 but they are nearly $400 and to me that is crazy. My question is this: If I find another 1/2HP 1075...

Make sure you notify your insurance company when the roof is replaced. Here in FL it will give you huge savings. Any roof over 7yrs old will not receive the best rates here. Also, I own a commercial building that had a tile roof. You think that they have 50 yr warranty but at about 25 years...

Good comments here. I used an at home test strip kit as well as 2 seperate pool supply companies to check salt level, chlrine and PH. I also switched salt. It's only 400 gallons so I would much rather pay a water bill than have skin issues. I routinely drain mine about every 6 weeks or...

My controller is Intelliconnect and a few months ago I had to download a new app and its never ben the same. I use Pentair Home app v 4.0.13 (5882)

SOrry folks. I have attached control panel and model below

I have Pentair Intelliconnect. I can not get the pad on the heater to go into any type of menu other than changing the time.

I've been a long time reader of this forum and have read a ton of great advice. I like to consider myslef a knowledgeable pool owner. I have had several in my life and never really had any real issues. I am 2 yrs into a pool that I had custom built. I did nothing really fancy except having a...

I am adding this just incase anyone else goes thru the same thing. I converted my normal bromine spa inta a salt water spa with a little add on device attached to the outside of the cabinet. I kept the salt level within range and at first everything was fantastic. I then started developing...