Recent content by tenderfoot

How does one remove a bubbler light from the pool? I have a SAVI bubbler light that is about a foot down inside a vertical tube that's on the tanning ledge, and I am not sure if I am supposed to be draining the pool down to completely empty the tanning ledge to take that light out. Has anyone...

I know, this is an old thread. But for the sake of others reading this thread in future, just as I did years after the thread was created, I just want to say that I ordered the PLC 1400 SWG from thepoolguystore.com and they shipped it for free over UPS within 2 business days of placing the...

Well darn it. It looks like the SWG cell is indeed close to its death. It is still breaking up the salt into chlorine, but the beeping and error code are back. Sigh... I just ordered a new cell.

I use the TF-100 kit. The water chemistry is now good, except for FC. It's just that we had a ton of rain this past weekend and I had just finished the SLAM process. I am still waiting for the FC to drop below 10. It's been declining slowly but steadily since Friday. I had the SWG off until...

I had never heard about the correct RPM to determine the clean filter pressure. Thank you!

Well dang it. It looks like my SWG may be on its way out 🙁 I heard beeping and holding down the D key gives me code 120. I am cleaning it now (water&muriatic acid), so we'll see if that fixes it. Else, gulp...

Yes! I always go through that as well. Lol

Thanks. Yes, crystal clear water now. So I have now cleaned the filter completely and refilled with DE. I am running at 1800 24/7 for now until I am comfortable with the chemistry and these weekend rains have subsided.

It looks like 1200 RPM was not allowing the SWG to kick in and do its job. I had a lot of algae this time around in March/April and I had never had this problem. I am in the process of doing the SLAM procedure. Gonna have to go up to 1300 RPM or revert back to my original configuration.

So, according to the Aqualink interface, I consume the same total watts by running at 1700 RPM for 8.5 hours a day as compared to running 24/7 at 1200 RPMs. So, I am going to stick to 1200 RPMs 24/7 for now. I used to also run the SWG for 4+ hours (50% of the pump running time) and that kept...

Thank you!!! Off to testing!

Thanks. That makes sense, but I am not sure how to determine if the SWG and filter "work" (or don't work) :) The water features do come on every day for a few minutes, just to circulate the water in those pipes. Those are only on for prolonged periods when we manually turn them on. So, I...

That was the time & RPM that the Jandy tool recommended for my pool setup. @All: Thanks for all the input! I am going to try running it at a lower rpm for 24/7 and see how that goes. I do like all the added benefits you've all mentioned and also the look of it when the pump is running. And...

I run it for 8.5 hours daily, at 1700 RPM. I had a calculator from Jandy at some point that I used to calculate that time and RPM to use to make sure the water volume would be all circulated once every day. I did not calculate the power usage on that as I basically just accepted that I had to...

Yes, I meant evaporation rate would increase if water features are on. Re: running pump 24/7: I will need to calculate the impact to my electricity usage. Curious: why does it feel wrong to you to be in the pool with pump off?