Recent content by takeadive123

Hello All, After having a RayPak technician speak live with our on sight electrician, it seems like we figured out the solution. Originally, our electrician connected the wiring from the Pentair unit to the wiring connected to clock/fireman switch slots on the motherboard. We had the...

Thank you for the feedback! We run the heater with the doors open and I’ve now taken off the top so that the system can get proper ventilation. I ran the SPA to the max heat and confirmed that it was heating properly. Now the heater is off and we ran the spa pump after to dissipate heat from...

Here are some additional photos of our setup. We usually keep the doors closed when not using the heaters and open them up when in use. While the top is covered, we thought the sides would supply significant enough ventilation, especially with the wind. However, if that isn’t the case we can...

Yes we let the spa system continue to run for five minutes even after the heater is off so not sure if that’s the issue. If anything we can gradually heat the spa overtime versus setting the app to max heat from the start to prevent overheating as well. By south hampton regulation we need to...

We are only adjusting the heat on the app and we have the heater (Raypak Model 406A) set to stay at 104 degrees. What we’ve noticed is that the pentair system is responding to the app commands as when we go to turn the heat setting on we can here the pump running. However, the heater doesn’t...