Recent content by smcdonald001

I'm having the same issue. Just updated my app and firmware today. Seems to be only the android app as my wife's iphone app is working fine. And from the control panel it is fine as well

Hey everyone, trying to get my pool going for the season now that it is getting warm in central Florida. I couldn't figure out why my solar heater wasn't working. Started looking at the intellicenter and all 3 sensors (air, water, solar) are reading "ERR". I opened up the panel. All 3 are...

Any others?

Hello, So I am thinking of getting my parents a robot pool vacuum for Christmas, not exactly sure on the budget but if we could stay under $500 would be great. I'd be willing to spend more if I knew it would really be worth the extra cost. They have an above ground 24' round pool, vinyl...

I would definately.change the plumbing from 1 3 way valve to 2 2 way valves. That way you can atleast run them simultaneously. Attached is an image on how i have mine programmed. You could have a boost mode to increase pump rpms when using both features. My PB also wanted to use a series of...

Djones, I also was hoping for this functionality, maybe we will get it soon. The intellivalves do have the extra 2 com wires for the functionality. And if you get a com expansion board for the intellicenter, it has several plugs that say "intellivalve only". Are each of your features on...

So i did try to program something like this, but I could never get the intellicenter to work like I wanted. I tried a "all features circuit group" set to turn on the 3 individual circuits and enable the pump to 2200 rpm. Problem is that after enabling "all features", if you turned off 1...

Dirk, not a bad idea. I wonder if they were closed (but at say 10%) if just the deck jets were on, pump at 1500, would you notice them bubbling up. My guess is no, but I would have to play around with it. I wish I would have had the builder put a few extra return jets in the sides of the...

So Im going to try to explain this as concise as possible, but on our new pool we have 3 valves on the return side of the water feature pump. I valve for the slide, 1 for the deck jets, and 1 for the sunshelf bubblers. All 3 valves are 2way valves (there are no return jets on this pump)...

Jim, pool math app says 7.6 is my target. But I always add enough to take it down to 7.4 because I was thinking that if I only lowered to 7.6 or 7.7 that it would be back up to 8 or 8.2 in less time. Is my thinkong wrong?

Ok I was thinking of going the intellichem or intelliph route, but reading all the bad reviews on here has me rethinking that idea. I think we will just stick it out to the end of 2021 and see how much acid we will be using at that time

We only use the features for maybe 1 or 2hrs every day or two (when we swim). So any idea what a "normal" amount of pH rise will be once the pool has finished curing.

Hello all, So we have had our new pool up and running for almost a month. We really have everything almost dialed in perfectly. FC 5 CYA 70 TA 70 CH 310 But one thing I am noticing is our pH is constantly rising. Will go from 7.6 to 8.2 in about 2 days. We are using between 1 and 2 gallons...