Recent content by Simearl

Same here. I have two in my pool and both have failed. Short of draining the pool and cuttin a hole in the wall i dont know what im going to do. I dont want to go back with the same lights.

I'm looking for a replacement led light.

I have searched the forum trying to find a thread on a replacement for the aqua lumen niche less pool light with no luck. Does any one no of a suitable replacement for this light?

Thanks

No the motor is still quiet. Today the pump is running on low with no issues. But, when I try to run the pump on high is will stop running with the motor being really hot. So I guess the question now is to replace the motor or the pump. I have priced the motor at $300 plus and a new pump at $750.

Now when I turn the pump on high it will run for a few min then shut off completely. The motor will be very hot. So it may just be the motor going bad.

The flow has reduced to the point that I have to run the pump on high most of the time. So a complete pump replacement is in order. I really would like to stay with a Jandy pump since I have had good service out of the pump. I just a little confused on what pump to go with.

I will be replacing my Jandy JHPU 2.0hp dual speed pump this week. This has really been a good pump been running 24/7 since 2008 and have had zero problems. I would like to buy the same pump but the JHPU is no longer avalible. Can someone give me some idea on what Jandy pump to go with? There...

You must be in Bartow or Gordon county for the dirt to be that red. I live north of Gordon myself. Who is the pool builder? Your pool build looks great.

I had a service rep for autopilot come out last summer to check the problem out and while here he put in a new tri sensor to see it would fix the problem. It did not, still had the low flow rate. He checkd the cell and told me I needed a new one. So I bought one and this did not fix it either, I...

PSI on the gauge is showing 7psi on low speed and 17 to 20psi on highspeed

I have a autopilot SWG that is not working. I am getting a check flow flashing alarm and the unit is not generating chlorine. More than likely the power supply is bad, but before I replace it at a $600 cost I need to check the flow rate. The pool builder use Flex pipe when he build the pool 6...

Ok I haven't post on the problem lately so heres the run down. I still need some help form someone who has experience with the Autopilot. I call a service tech that was listed on the autopilot website from atlanta. The guy drove to my house which is 70 miles away from atlanta, check out the...

thanks, Its making cholrine right now so Im not too worried. Im going to call a technican out to check it.

Went out to check the pool this morning and I notice that the red ligth was flashing on my autopilot. It was giving me a check flow/clean cell warning, so I took it a part the strainer was clean and the cell looks good. After putting it back together it now is giving a purifier off/check flow...