Recent content by setsailsoon

Where there's a will there's a way! Great job and please do post a photo of the completed repair.

You should be able to confirm looking at the fittings. They should have 1" usually stamped on a flat side somewhere or on the edge.

Couldn't agree more. Proper trouble-shooting can save a LOT of money from replacing perfectly good components. Last time I checked gas valves are extremely pricey.

These FRP housings can't take a lot of of over-tightening. Take a photo of the housing you are threading into then blow it up on your computer. Examine the whole thing carefully. If it's cracked very likely you can't see the crack with naked eye. Blown up just a little will reveal this...

Doesn't look like you're getting much response. May this reply will help. If not try their locator for authorized dealers near you. Chris

That makes sense and probably why you can't buy a new one anywhere. Thanks. I should have known that!

Just because it stopped actuating doesn't mean it actually failed. Much more likely you have something else that is preventing voltage to the solenoid.

That's really unusual. In my experience they almost never fail. I would also think you can just replace the solenoid... if it's actually failing. How have you determined that it failed? Have you checked voltage to it when it is supposed to open?

Who dat! Welcome to TFP Edle! You came to the right place. I've got a little reading for you while you get your test kit on order. You'll need it to care for your pool. We don't sell them and we don't sell anything. That's why we are the best place I know to get pool advice. Don't go to...

OK my test results are in. Liberally apply silicone lube to plug fitting works great. Completely dry today. If it's not dry blow it out with your mouth. That works fine too. Yellow blinking charge light. No red light.

BTW I made a few changes to the system and it's improved a LOT. I moved the injection point downstream of the pH probe. Even with .1 second pulse of my solenoid valve I'm still getting a pulse of tiny, tiny bubbles after all. Looks like I'm going to need that diffuser @JamesW recommended or...

I used borates on my previous pool and they worked great. May still have some and I have the chemicals to do the borate test. Need to read up on @JoyfulNoise posts about that test. Never knew they'd reduce scaling. I also never had scaling before... always thought it was because I kept CSI...

Joel, What brand and model on the swg. Get a Taylor K-1766 salt test and test your water for salt before you add any. You'll be surprised how much you already have and if you assume 0 you'll definitely end up too high. Use Pool Math to calculate # of salt needed. Most brands want you to...

I keep mine on the patio next to the outdoor receptacle where the charger plugs in. It's 10' from the edge so charger doesn't get wet and is in the shade all day. To facilitate draining of the water in the charging port I have a 3' piece of 3/4" pipe and I set the other end on the pipe. Chris

Just tried this. Worked like a charm. A little bit of a pain to hold it up in the air and blow on it but works great. Started with yellow blinking light.