Recent content by seeclearly

Update! WE GOT IT OUT!!! With the water level as it is in the picture, and the clogbuster inflated but not exactly right where you would want it, my daughter's long armed bf got in the pool, shoved it upwards from the outside and grabbed it from the inside. Someone with shorter arms couldn't...

Update -- Got a temporary pool set up and mostly filled. Found out our heater has died and it blurped a lot of rust into the pool when I turned on the pump. We have a main drain, so I had turned it on to start getting the water up to speed. Anyway, the rust all settled and pretty much has been...

I'm still working on it. Got 2 temp pools, working on getting the water cleaned up a bit. Lots o' greenish brown crud came out of the return when I fired up the pump. We got a thing from the hardware store that is for breaking plumbing clogs. It is 2 feet long and 2 inches in diameter, pumps up...

The expensive thing about water trucks is the water truck itself, so it would be cheaper to go buy a 16' Coleman pool at Walmart for $250 - and they still have a few. We are looking to have a very hot summer so I'm pretty sure I could resell it and recoup a bit. I've been making a lot of...

The auto body bags are $75 on Amazon -- not the most expensive pool gadget I guess, but hoping not to spend that. I will post a picture tomorrow of the liner with the rake handles stuck down the side. Can't really get a picture of the offending part as it is down at the bottom of the side wall...

Another idea that has been "floated" is to dig under the bottom rail. The bottom rail sits on flat concrete blocks and there is a foam cove but no bottom liner.

Ok, I'm an idiot, but what do I do now? We are putting in our first replacement liner. Had to get water delivered because our well is too slow. We weren't really sure when we were supposed to remove the shop vac hose from the skimmer opening, and now the pool is full and the shop vac is still...

Thanks for the help! Good tip on the vacuum hose.

It doesn't pour out, it drains away into the pool. (Normally it would pour out, seen by the washing of the skimmer window when in use) At its partially full state, the pump is above the water level. So then I'm guessing I can't get suction until the pool is full enough to get the pump below...

Hi all, I'm replacing my liner for the first time ever, and have a bunch of water I need to get out of the pool. My aboveground has a main drain (as well as a dished bottom, so there is a lot of water). I should be able to get the pump running and backwash out the water using the main drain...

I found a&h washing soda at the first old-school hardware store I went to, and got two 55 Oz boxes for $10 (and a cool weeding tool - they have neat stuff in there). Over the past 4 days I've been watching the chlorine drop and the pH and TA go up. Currently FC 5, TC 5, pH 7.2, TA 70. Borates...

Thanks for the very quick response! I had forgotten about the pool calculator and was just getting to it. For some reason we aren't getting electricity at the pool and my regular electrician has a full time job now. I'm working on that. In the meanwhile, to keep the pool from getting mossy we...

Well, we're having a sudden heat wave so it is time to open, about a month ahead of schedule. I forgot all about ordering this boric acid and am going to do it now. I am guessing powdered over granular for quicker dissolving? Is there a link to a chart that says how much to put on to raise the...