Recent content by scott.kiran447

Problem fixed. The phantom step that started the pump at 11:32 AM no longer occurs. Clearing the memory fixed the problem. Clearing just the schedule didn't. @generessler, @HermanTX, @MSchutzer, @ajw22, thx for the suggestions! Scott

These are all really good suggestions, @generessler, @HermanTX, @MSchutzer, Thx! LOL! Thx for the laugh! The ESL and Maintain temps are disabled so that isn't problem. I think I have a few actions. Check the pump and clear the Intelliflow3 VSF if that is possible. Clear the...

Got it...thx! However, my problem isn't skewed time: The system runs all the expected steps, but it seems to add a step at 11:32 AM that isn't visible--it is a ghost instruction seemingly. While the pump/filter correctly start at 5:00 AM and stop at 11 AM, they again start later at 11:32...

@awj22 and generessler, Thx! I set the time through the app, and there is a separte system clock on the controller board? How do I "see" that clock, RESET it, and ensure it is set correctly? The board/system are new, replacing the old one, which failed and seemed 10+ years old. So...

Hello, New Jandy Aqualink RS8 with 3.0 Antenna, PLC1400 SWG, and new Pentair Intelliflo 3.0. Pool and Spillover spa. I program per the attached image and pump should be off at 11 AM. Strangest problem is the pump turns on consistnetly at 11:32 AM. This is not programmed...