Recent content by Sbcmurphy

  1. S

    New VS pump installed and now has small bubbles coming out of returns. ASAP fix or do I have some time?

    Thank you for the reply! I had them come back out and install a union. The pump runs great at high speeds but when it switches back to low, it loses some water and I get air bubbles again. Switching back to higher speeds eliminates the air bubbles completely.
  2. S

    New VS pump installed and now has small bubbles coming out of returns. ASAP fix or do I have some time?

    Just had a new variable speed pump installed on my inground pool. 3 hours later and there’s still tiny bubbles coming out of the returns. The water level is fine and I’m topping it off a little more just in case. No vortex in the skimmer. The pump basket looks good - no water bubbles at full...
  3. IMG_6346.jpeg

    IMG_6346.jpeg

  4. IMG_6344.jpeg

    IMG_6344.jpeg

  5. IMG_6343.jpeg

    IMG_6343.jpeg

  6. S

    Eye test not matching chemistry results

    Hi, It doesnt brush off at all, but has faded a bit with daily vac. Current numbers: 12k gallon vinyl, using 12.5% liquid chlorine FC: 10 CC: 0 pH: 7.6 (my chlorine is high but pH hasn't changed once in two months) TA: 80 CH: 40 CYA: < 30 but greater than 0 Temp: 78
  7. S

    Eye test not matching chemistry results

    This past week I noticed some faint green / yellowish spots at the bottom of the pool, along with small white spots. They are pretty hard to spot, as evidenced by the photo below where you can only see faint discoloration. Either way, there are 3 of these spots that weren't there before. Now I...
  8. PXL_20210710_142722761.jpg

    PXL_20210710_142722761.jpg

  9. S

    How much chlorine is too much before closing?

    Hi all. I had a trouble free first summer of pool ownership thanks to this forum - clear water, no algae and a newfound understanding of chemistry. Then 3 days before closing I noticed a small green stain in the deep end. I went a little heavy handed and brought chlorine up to about 27ppm on...
  10. S

    Replace SharkVac power cord?

    Not yet, I'm being stubborn. Literally just started wiggling the cord and straightening out any knots in the wire. So far it's working about 80% of the time. Next year I think I'll splurge for a new dolphin!
  11. S

    Replace SharkVac power cord?

    Having a funky issue. I inherited a Hayward SharkVac (not sure how old but not one they sell currently). It still works pretty well, but lately it stops mid cycle and I have to "jiggle" the power cord and it'll kick back on. It doesn't trip the GFI outlet and I don't see any tears or visible...
  12. S

    pH hasn't moved in 4 weeks?

    Ha, I apologize if that comes off as a brag (or worse... a humble brag!) With all the guides saying to test pH daily I assumed I'd be adjusting it much more. But if I'm lucky I'll take that too...
  13. S

    pH hasn't moved in 4 weeks?

    First, I want to thank everyone here for making my first month of pool ownership a great success. Everything has been really smooth (aside from the opening SLAM stress) to start the year. Weird question, but should pH be so stable? After the initial balance, my pH has been 7.6 every day for...
  14. S

    CYA Troubleshooting - Levels still low

    Nope, I did all my tests prior to the rain. I haven't backwashed or drained since adding.
  15. S

    CYA Troubleshooting - Levels still low

    Hi all, Could use some guidance troubleshooting my CYA levels. I started the year at 0, with no cloudiness in my k2006 test and confirmed by pool store test. I've added nearly 4lbs to my 12k gallon vinyl pool which I thought would get me to the 35-40ppm range, but my test still shows it below...