Recent content by Sam337

Thank you @Jkrags! I too have the SuperFlow VS and I too started getting Error 0021. I tried checking and verifying all the wiring and connectors including grounds, but continued getting the Error 21 and the pump would shut down and re-prime a few minutes later. Then I saw this post about...

Slightly different than the issue of fine dust, has anyone else had an issue with small debris escaping the basket and expelling from the impeller/exhaust port on top (apologies if this has already been asked/answered)? We have small seed-like debris this time of year and on the maiden voyage...

That was one of the original issues though they fixed it and after the fix the incline was not a problem. My pool incline goes from 8.5' to about 3.5'. The issue they were not able to overcome is the rounded corners of my pool. The programmed logic for floor only mode was not able to deal...

I finally returned the Seauto Shark for a refund, and was able to get a refund on the Asurion extended warranty too. After about five iterations of their software/firmware to correct navigation issues, it still wasn't right. I give Seauto credit for trying and if they stay in the pool robot...

@Jimrahbe Yes, actually I do have them if you're interested. I indicated I wasn't offering them because (IMO) there's no value and I don't want to pass on bad parts. The motor housing is open and one of the motors is dissected.

I am offering parts from a Dolphin S300i that ceased functioning. I'm not offering the motor assembly, the blue cord, rubber parts or gears as they all needed to be replaced. The unit is/was 4.5 years old and the parts show normal wear and fading. The power supply functions well - it's the...

Update: After providing my feedback to Seauto (navigation issue plus non-responsive unit), and after one additional troubleshooting attempt to revive the unit, they quickly offered to send me a new robot and also advised their latest firmware update should fix my issue of the Shark robot not...

If I had a robot that lasted 14 years I'd be tempted to simply buy another... assuming the manufacturer has not value engineered away the quality over the years. I had a Maytronics Dolphin S300i that recently died after 4.5 years. From what I've read, that's about average. I am also in the...

I ended up pulling the trigger on the Seauto Shark for $425. Exciting because it has brushless motors and actually does waterline, walls, and floors separately. It's a cool unit and there's a lot to like as I try to keep my annual cost of robot ownership low but unfortunately, IMO, not quite...