Recent content by rotorsailor

Purple 3 am fuse was bad. Replaced it, and the other 3 fuses are all good. Guess water must have got on the ICB. Is this difficult to replace?

After looking at an enlargement of the ICB, there it was in the upper corner. Pulled it out, and it is blown. So I will be down to the pool supply tomorrow for another one (and a spare!). One thing I wasn't told when the unit was installed 5 years ago, was there was a packet inside with the 3...

I can see the three slow blow fuses, but not the other one. Is it somewhere on the iCB enclosed?

I have a fuse kit, but can't find the automotive type fuse on the panel. Where do I look?

Thank you for that advice. I will check the fuses - didn't realize there were any on the control board. Will post how it turns out. In my area we have Pinch-a-Penny as a pool supply close by.

It was the plastic keypad cover that blew away. A short in the display board sounds logical, as there was space where water could enter. Is this something I could easily replace, or should I call the tech?

Moved from here Having a problem with my Hayward H250 gas heater. Digital screen went blank, plastic cover blown off. Now no power. CB recycled and appears OK. I ordered a new face plate, attached the plug in - still nothing showing. Is this something I could easily check, or should I call...