Recent content by Ron19742

All of the numbers are from the solar touch display

I have a solar touch controller connected to a Pentair 011018 pump the target temp is 88 water is 68 solar temp is 91 green light is on the display still shows "Solar Heat Off" I can manually control both the valve and turn on the pump with the solar touch I have it in Heating Enabled Am I...

Update ordered the pentair breaker and installed in the GE sub panel did not change anything else, everthing seems to be good now

The wires are straight from the breaker to the switch to the pump no other splits except for the ground

Thank you for any advise i may have to order the other breaker after I confirm that it will work with my sub panel I have the breaker in a sub panel in the garage, black and red wires to a double pole double throw switch near the pump and then to the pump. Green runs from the breaker to the...

I bought a ge 20 amp 220v. Gfci breaker for my new intelliflo and it keeps tripping the gfci. Is there a special breaker for the pumps? This post just confirmed my question on what to do with the neutral connection on the breaker. So I had it wired right. If they breakers are the same...

Thank you I will look into it further

the Controller information is here https://shop.solardirect.com/pdf/pool-heaters/solar-pool-heaters/controls-sensors/goldline-aquasol-install-manual.pdf I am not sure the pentair allow the for control through the relays? It looks like I might have to buy more parts to make them talk to each...

I am adding solar panels to my pool and will also be changing out the pump. I want to go variable speed. The solar system came with a Hayward Auqasolar TC controller. I don’t see an easy way to make it work with the VS pump. I am thinking that the best bet is to sell this off and get the...