Recent content by RodRamos

This is exactly what I'm wondering. I dont mind draining the pool just below where I want to add the return but I'm terrified of cutting both the steel wall and the liner at the same time and messing this up.

Ok I will try to explain this as best as I can. So we installed an 18ft steel wall AGP. It came with two pre cut holes in the steel wall, a square one for the skimmer and a round one halfway down the wall for the return fitting. Everything works as intended. Now here's the pickle: I want to add...

I did just that. Thank you. Worked like a charm.

.

So I'm trying to hard plumb the intex Krystal Clear Pump/Filter setup below. I tried using the connectors in the picture but the 1.5 PVC pipe is about a millimeter too big on all sides. Are there any other adapters I can use with 1.5 PVC? Thanks.

Thank you. Makes sense.

Hello. What are you guys selecting when the pool is pebbletec or gunite? I only see three options Vinyl, Plaster and Fiberglass. Thank you.

Yes I do. https://www.walmart.ca/en/ip/blue-wave-poolwatch-pool-alarm-system/6000193648473

Just saw the filter is for a 1/2 to 3/4 hp. Guess I'll keep looking for a sand filter to match the pump.

Setting up an above ground pool burried 2 ft. Pool is a 18x52. Is this combo ok? https://www.amazon.com/dp/B01AAWQRUY/ref=cm_sw_r_cp_apa_i_snybFbRNS2MNY https://www.amazon.com/dp/B083Z8JNX2/ref=cm_sw_r_cp_apa_i_NsybFbA05K99S Thank you.

I'm planning on spraying the outside and inside walls with rustoleum spray paint. I was also considering wrapping the bottom in plastic but I'm concerned that it will trap moisture between the outside wall and the dirt. Im going to hold off on the SWG for a bit. Thanks is everyone.

My sister has an in ground pool and has a SWG. Ever since I went swimming there when she bought the house I've been sold on the salt water system. Forward to now and were adding an above ground pool and burying 2ft. The pool isn't specifically designed to handle salt water, at least it doesn't...

So were getting ready to install our brand new 18x52 steel wall AGP. Were sinking in 2 feet into the ground with a retaining wall around the pool to avoid pressure from soil in case we need to change liner or what not. My question is, what's better for the installation, a leveled sand bottom...