Recent content by ROCMILLER

Thank you. This signature thing is killing me. All my info is in there. It’s not populating for some reason

Thanks. In the meantime I wanted to run these numbers by the group I have spent the past two days refreshing my water to bring my CYA down from 90. I’m sitting at 50 currently without a pool dump TA 120 PH 7.7 FC 2.5 CC .5 TC 3 I know I have to bring my FC up and my TA down per pool math. I...

I received my TF-pro kit earlier this week. Just need to confirm this is correct I have a blank mixing bottle with a red cap. This has no marks or volume indicators on it. Per the instructions I mix 7.5ml of pool water and another 7.5 ml of r-0013 stir, sit, shake and test. I want to mark...

@mknauss im going to dump the water as you suggested. You comment about liner shift gives me a little pause. Looking at my last step it’s roughly 12 or so inches below the bottom of my skimmer plates (opposite side) - which is my mark for draining the pool before winter closing. Can you...

Ugh. I've literally drained 10% of the pool 3 consecutive times over the past week to get rid of the FLOC.

I fought an Algae problem last week. Before reading the forums and pool tips, I floc'd it, triple vacuumed every to waste and added about a gallon and half of liquid chlorine. That cleared the pool up in the short term, but I still have a few spots of Algae pooping up on my sunledge, steps, and...

Got it thanks. I left out one detail. I did have skimmer socks in when I used the FLOC. Maybe this helped prevent any damage?

Dumb question is the signature part of the profile. I thought I put that info in Vinyl in ground, 35k gallon pool, sand filter 1.5hp pump single speed.

I’ve been dealing with some pool cloudiness for the past few weeks. Initially I thought it was pollen. Been sweeping, runnning the vac, backwashing, etc. my chemical levels have been a little high (as indicated by the pool store — I just bought the TF-PRO kit so never again with them) Anyways...

That’s a fair statement. I’ll move the temp up to 85 to see if I can feel the difference. I have a waterfall diving board so outside of the pool. I should def feel it there at that temp?

Any help or ideas are appreciated here. Opened the pool today. Everything went smoothly and is operating as it should with the exception of my Mastertemp 250. The unit is firing. Heat is being exhausted the coil housing is hot, but the water is not warming at all. I called the company that...

I have a double pull 60 in the house feeding the intellicenter

Hoping someone can help answer a question. I have a intellicenter loadcenter currently feeding pump, heater, filter, two led pool lights. We are in the process of adding hot tub and a shed. As long as the load doesn't exceed what is being used, can I use the loadcenter as my sub panel and bring...