Recent content by Roberd07

Yes, as far as I know it’s flagstone.

The leak detection company ran a bead of waterproof epoxy up under the length of those capstones. The bead is thick enough that it really seems like it would have stopped any leak up under the capstone but who knows. The water level does seem to drain down very close to where the tile meets the...

Pool/spa configuration.

This is the lowest level that it goes down to, just below the capstone.

Absolutely, I’ll post some pictures first thing in the morning.

My spillover hot tub drains down to the same level every night which is just below the sandstone cap (between 2-3 inches) that makes up the spillover. I have had the same leak detection company out twice to diagnose the leak and they did apply some epoxy to a suspect area (receded mortar between...

Thanks for the info. I’ll try that today.

Honestly I didn’t know if it was cemented or screwed on. I‘ll definitely try that.

I have intermittent bubbles rising from the jet opening shown in the picture. The bubbles are coming from the small clearance between the pebble tec surface and the gray jet housing. I tried to capture a photo as best I could of the bubbles. I should add that I also have intermittent bubbles...

Looks like a new pump it is. Thanks.

Motor/Pump is starting to make a lot of noise so I’m sure the bearings need to be replaced. The motor is a Century B668. I’ve searched and searched and I’m not able to find part numbers for the bearings. Does anyone know which bearings this motor uses? And is it advisable to replace bearings or...