Recent content by rich6429

But it was crystal clear just right before the heavy rain. Could this be algae in my pool that propped up just after the rain? Or algae from the rain? I’m not really sure what is happening. Ugh.

when I shocked it a few weeks ago...i did get to 28ppm. are you suggesting that I shock again?

I normally go overkill with testing...and pool has always been on point and has that TFP sparkle. That said, opened the pool 1 month ago and havent really been in the water much. Maybe 2-3 times since opening...so needless to say, not very active. I SLAMed after opening and had the...

I tried to move the thread under "opening/Closing" but unable to delete this thread.

Not my pool…but my sisters pool. 2nd opening this year for this brand new pool. Last year upon opening, it had the same crinkled liner (shown in picture). PB said it was due to sump well not being drained. The liner was fixed by PB by draining half the pool and putting the vacuum and filling it...

Not my pool…but my sisters pool. 2nd opening this year for this brand new pool. Last year upon opening, it had the same crinkled liner (shown in picture). PB said it was due to sump well not being drained. The liner was fixed by PB by draining half the pool and putting the vacuum and filling...

so...can someone check if my steps below is the right steps to take? SLAM pool let pump run for 24 hrs drain pool after 24 hrs Close pool add polyquat roughly after a few days depending on FC. only reason I have 24 hrs...is because I dont have a lot of time between now and closing the pool. I...

Thanks. All of that is really helpful. last question just for my own clarity...there is no way to have one pre-set stop? the 2 stops are now 0 and 24...but can it be 0 and 18?

ok thanks... so I have setup the home stop "0" and another stop. I have been playing around INtellicenter, but cant seem to find a way to control it using the Intellicenter. CAn you assist?

Thanks. Does that mean I would connect the 3 pin to Valve A or B? If so, what about the green/yellow wires? Also, although the “on/off analogy” is fine as you explained, I thought I was able to do a 75/25 split if I wanted to with the Intellivalve.

I just got an Intellivalve that will control my pool returns (which will be primarily on), and if I have to turn on my water feature. So it is going on a 3-way From a wiring standpoint, do I just put the 3 pin in either the Return or Intake? I also see other wires (yellow and green) in the...

Wondering what you all do when winterizing your equipment. Do you leave your Intellivalve hooked up and wired in? Or do you take it out and disconnect from IntelliCenter during the winter period? I keep everything out with the exception of my salt cell.

Apparently, according to the technician that serviced the heater...it is also a common issue.