Recent content by rgnbull1227

Replaced the element. That was the cause. There was a little rust inside on the element where they come through to the Electrical connections. Thanks for all the help.

thats a really good point. Any idea how to ID the relay for This unit? Its a Balboa VSS.

Correct. I disconnected the two copper tabs from the heater element and spa runs as normal. No tripping breaker.

Yes and tripping immediately when power is present, NOT when the system is calling for Heat.

Just tested from the heater posts to the ground. NO Continuity. If I test the ground to the outside of the heater tube, there is continuity. When testing resistance to ground, the numbers start at 8 and keep climbing to 30+

Have a Swim Spa and the GFCI trips immediately. Went one by one and disconnected components. Culprit is the heater but I replaced this element April of 2023 and never had issues. Tested continuity-GOOD, Testing Resistance-NORMAL RANGE. No corrosion on posts etc. Any other ideas why the...

So yesterday I noticed a slight cloudiness in the pool. Otherwise perfectly clear. This AM more cloudiness and tested using my Taylor Kit. FC 11 CC 0 PH 7.4 CYA 65 Any ideas why I may be getting a bloom at these levels?

So my Heat Pump is running fine other than the fan seems louder than normal. Usually quiet. There is no wobble but when I pull up on the fan (When its Inverted) I do notice the shaft and rotating motor comes out about a 1/2 to 3/4 of an inch. I assume the shaft/fan should stay solid and not...

Thanks, its not bubbles. We had about 5-6 inches of rain since sat. Haze got a little more milky on Sunday, dumped in 2.5 gals of 12.5% Liquid Chlorine. Pool is crystal clear today, even with about 2" of rain yesterday. Had to pump pool down on Sunday 2" due to rain and today the pool level...

Test Results FC 12.5 CC 0 PH 7.4 CYA 65 Alk 100

So went out to shut off the SWG and start the OCLT and I noticed the pool is almost totally clear again. Haze is just about gone. The only thing I did today was turn the SWG on "Turbo" which is 100%. Same speeds and schedules. Being that we are supposed to get heavy rain tonight I think I...

Hey Neighbor. Whereabouts in Quogue are you?

Will try OCLT with pump running. But, being that everyday my pool maintains a steady 11 PPM FC and 0 CC Level would suggest no blooms no? The haze has me stumped.