Recent content by Rev173

Thanks James. I had the cell tested and it was bad. Just bought a 940. I hope the circuit board isn’t fried as well. Might have to sell one of my kids to pay for it!

Here is a pic of sticker on cell. I also took another look at the circuit board. On the back there is a small dark mark on the opposite side of where the plug goes. Kind of hard to see so I circled it. Does that mean the board is shot?

I have a multimeter but not a whole lot of knowledge in what I should test and what I’m looking for.

The cell was installed with the system when we put the pool in 5 1/2 years ago. I will post a pic of the label and serial number in a bit when I get home. Never had a problem with the cell showing low salt reading before. Worked fine last summer then this year upon opening a couple weeks ago it...

It’s 5 years old.

Thank you sir. Great info. What’s the best way to determine if it is the board that caused the issue?

Hi Everyone I've read through several posts and have a basic idea what my issue could be, however I haven't seen anyone that has had burn marks on their SWG plug. My issue started when I opened my pool two weeks ago. I have a Hayward Aqua Plus with a t-15. I received a low salt warning, but...

For what it is worth I think it looks great! Does not look too big at all!

Hey guys. I was wondering what the preferred method is for placement of control joints in cantilever coping? Is there a certain distance each cut should be? Should the cut continue around the edge or stop at the top of the cantilever? Finally, is it best practice to have cuts at each anchor...