Recent content by re76pbm

Thanks for your help.

It looks like by step 3, I need a new ICB.

Yes I did all 4 steps.

Yes I did the tests for the BD code. The fc4 fuse is good and I'm getting 120V at the control board.

I definitely have a H250IDL2 and the "Installation, Operation & Service Procedures" that came with it. There are two sets of codes in the manual. There is a Troubleshooting Chart with a list of codes including BD. Then a few pages later there is an Error Codes chart which includes the bD code...

Thanks for the link to the trouble shooting guide. The guide only mentions a BD code (B&D both capital). I am getting 120V over to the control board, in which case the guide says to replace the ICB. The code I am getting is bd (both lower case). In the manual for my unit it mentions a bD code...

fc4 fuse is good. I'm getting 120V over to the control module.

I have a Hayward H250IDL2 heater with Service light with a "bd" code (both b and d are lower case). This code is not in the manual. Does anyone have an idea what this code refers to?