Recent content by Randy_Pool

That fixed it, I knew it was simple. Thanks so much again!!!

Here are the config pages as well as a picture of the panel, pushing the "air blower" button ( #2 ) starts the air blower.

So I have been updating my Neighbors pool with modern Pentair equipment. First and easy touch 4 and SWG. Next I added screen logic. Finally added 2 automated valve. Basically I have everything working, we can turn from pool to Spa mode from either the Panel or from the screen logic interface...

The "flakey cell" is not even installed anymore as I got that one from a friend, it's working perfectly.

That's what I told him when he said "chlorine Tabs are just so much easier"... Well I disagree, but in this case THANK YOU! I do think the economics for salt cells are not much better than buying Cl tabs. We seem to spend $150/year on "Cells" ($600 every 4 year) and another $100/year on salt...

It seemed to work fine for alot longer than usual yesterday, 4-5 hours. I did reduce to out put down to 80% and then 60%, there was no immediate impact however a half hour later I saw the red flow light come on. Not sure how or why that could cause it. Maybe the cell electronics are sensitive...

Its 100% with all led Solid and is on/off for about 265/35 cycle, I didn't use a stop watch.... I have already un-jumpered the flow switch as it wasn't making any difference.

Yes I agree, about all i probably proved is...If the flow light is Green The cell is probably generating chlorine. For what ever reason it seems to be working fine for that last several hours. It has been showing low flow "most" of the time for the last week at least.

Set to 100%, All looks good at the moment... Flow green, and cell light on and a few minutes later cell light off. At 100% should the cell light ever go off? Seems to me that there must be something wrong with the control board on the Cell. Working for a while, then stopping.