Recent content by popechild

I have been running it 24/7 for a while without issue until the sub-freezing temps. Or rather, I thought I was running it 24/7. Turns out my three speeds (which pre-freeze I set to all be 3450 rpms) actually added up to 23h 45m, so there was a 15 minute window in there at some point that it...

I've noticed a few times now that my Pentair Superflo VS will quit operating during freezing temperatures. There's no external freeze protector type of hardware and the pump is wired directly to the equipment pad subpanel (no automation center, etc.). During previous freezes, I've only noticed...

Thank you.

Following up on this idea, do I actually even need a 3-way valve, or is what I need just a 2-way diverter? There's only 1 in and 1 out. Seems like if I just close the diverter it would force everything the way I want it to go, no? Assuming the 2-way diverter will fit inside the housing for the...

Also an interesting idea. I am indeed planning to run the pump all winter, but in Atlanta we do occasionally get long enough freezes (like last winter) that I'd rather not count on the pump to be the sole source of protection for the heat pump.

That's an interesting idea. I had not considered or seen the spool idea, but it makes sense. Thanks!

Following up here. I took apart the valve and checked it for any signs of tears, dirt, etc. Everything looks brand new (it was installed less than a year ago.) Put it back together trying to make sure it was as secure as possible, but still leaked. Bought Magic Lube and took it apart again...

It's a good idea. I don't see any sign that any used ones, broken or otherwise, have come up on ebay when looking through past results, and I'm guessing it'd be hard to get lower than the $70 the cap will cost unfortunately. Looking like I might be stuck having to shell out the dough for the...

Yeah, unfortunately I don't really have room without some significant modifications. Just outside the left edge of the picture is a 45-degree elbow, which would mean I could fit one on that side but it would be tight and getting the placement precise enough that it wouldn't throw off the...

I thought about that, but the way this is plumbed I'd still need two of their custom unions, plus 2 elbows, and the turns would be in a pretty small space that would make getting the length of the cuts right a challenge. Not impossible, but enough hassle on top of still needing to buy two of...

Thanks!

Okay thanks. I'm familiar with the spring nature, but not having used one before, wasn't sure if I was over-estimating how good a job it was supposed to do in staying shut. So you're confirming that it should stay completely shut at all times that water isn't pushing through from the input side...

Hi, I'm looking at the best way to winterize my SJ35 while keeping the pump running through the winter. The manufacturer suggested I purchase their winter cap for $70 (with shipping), which seems like a ton for a simple plastic cap. Has anyone else come up with a more affordable method for...