Recent content by poolmom314

Hello TFP, I wanted to get some advice on replacing my Hayward Astrolight 120v pool light with a Hayward Colorlogic 4.0 LED 120v light, and my spa light SP-591SL to Colorlogic SP0535 (S). I have a Jandy Aqualink RS PCB system which I had upgraded to the iAqualink last year. The lights have...

Paul you're a life saver! That's the one, bp electronics! Thanks so much! Helen

Last summer I had read a post on TFP that listed the name (and maybe address) of someone who was able to perform repairs to an:roll::confused: Aqualink PCB. I thought I had bookmarked it, but now I cannot seem to find it. If I recall, he may have been someone who actually designed the...

Thinking of trying another option for the tripping GFCI outlet on my Aqualink RS 8 panel. The outlet is currently in the knockout on the side of the panel. Replaced it twice already. Maybe the pool light we installed last year is a higher watt than the previous one? Would this make a...

Re: Aqualink RS 8 "clicking" noise in panel, pool light stays on, actuator not turn So..over the past two days I've changed the GFCI-twice. Changed the pool light and filter pump relays. So no more clicking at the board. Disconnected the 4 button spa switch and ordered a new one. Checked...

Aqualink RS 8 "clicking" noise in panel, pool light stays on, actuator not turning I have an Aqualink RS8 all button pool/spa system. Last week the pool and spa lights came on when the system went into spa mode. Neither the home controller or PCB showed that the pool light was on. Light...

I have a pool/spa combination and have two JVA 2440 actuators on compool valves. I noticed they were leaking from underneath, where the cam actually sits onto the valve. I changes the gaskets in the compool valves. But they were fine to begin with with. I took off the JVA 2440 and opened the...

thank you Craig ,,,

Hi Ping Thank you for your advice, quick question , did you pull wire from inside the pool or at the electrical box ?

Thanks Dave, I thought so too.. As that actuator is turning when the GFI trips, regardless of the mode the PCB is in. Thanks again, Helen

Trying to remove the pool light from my pool. Wires are disconnected from the power block. It's not pulling from either direction. I got in the pool and pulled at it with full force. The Niche is removed, I just can't get the wire to go either way. I do have a spa but it has its own conduit...

I have a Jandy Aqualink RS 8, it is 11 years old. We had an electrician look at it the other day because one of the side outlet gfi's kept tripping at strange times. Then it tripped when we had the sytem in spa fill. Then the Jandy Spa actuator valve was in the wrong position, even though it...

Thank you for all your help...I replaced the Capacitor and VOILA! it works perfectly! Thanks again!

Thank you! I will search the thread now... The pool guys kill me. I am so thankful I found this forum...

Thanks for all your help!