Recent content by petedog85

I used a fluke multimeter. Yes, I tested L1 and L2 at the pump and was getting 240. I then checked continuity and got an open circuit. The pump motor display is blank/off.

No, nothing out of the ordinary and my pool is about 8 yrs old.

I have a pentair intelliflo 3hp, VSpump and it wont start/run. I have power going to pump but no continuity between phase to phase. Its open on both phases on the motor side. Please help!

Thanks anyway!

I need your help. My jacuzzi light kept turning on and off every few minutes. Every pool guy I talked to said it may be the motherboard. I put in a new motherboard and its still doing the same thing.

My heater stopped working suddenly and won't turn on via phone app or iAquaLink remote. The panel show what I think is an error code, it says Ad0. I can, however start it manually though. I think it might have something to do with the stack flue sensor!? Can anyone please help?

Yes, both suction and disch. are 2.5" Air vent is 2.5" pump model # is WFE-8 Im going to put a plumbers plug in 2 of the jets tomorrow and see what happens.

Well it's a 2HP pump and if you look at the pic above, the discharge is 2" and then steps up to 2 1/2" before it goes into the ground.

ITR, No Im not sure. But I think I need one due to the fact I need to blow in the vent real hard a few times to get the bubbles flowing. Im sure or hope there are blowers out their that are not too loud. https://www.youtube.com/watch?v=Yw8ZAzzwxVI

17x35, spa is 8x8

- - - Updated - - - I have more but it seems i have exceeded my quota.

8 jets and the spa is roughly 40-50 ft. from pool. Booster pump is dedicated to the spa without going thru filter or htr.