Recent content by Pas_pool

Going to start it now. For SWG. Just pressing the less button until no % shows means it’s off right? (Tried looking in the manual but didn’t see it)

I did not add stabilizer yet. Was going to add it to a skimmer socks and about 2 pounds. But I will wait. Added the muratic acid about 45 min ago. Now adding two bags of salt. Then I’ll do my first test for the overnight test

Sounds good. I’ll message you

Yes I did that. But the black dot only went away if I squirted harder and bubbles formed. It sounds like we have low stabilizer if it didn’t blur. I have skimmer socks. I’ll use pool math and see how much to add. Thanks.

I double checked with a test strip to see if that shows low stabilizer too and it does. So I think it’s low. Thoughts?

I redid the text and I did it outside this time. Now clarifying question. If I squeeze the bottle into the test tube fast it does blur away but that could be from the bubbles right? Or is that the way you do this test? If not. And you squeeze slowly this was the end result with the water all...

Great. Thanks!

Sounds good. Thank you! Will be doing this this after work as well.

Might be a dumb question, but as I have never done it before. Does it just get poured in the pool water? And specific location or doesn’t matter.

That is what I is saying to lower it to 7.6

Just upgraded my pool math subscription. I’ll check it out. And add my first test results from tonight.

I’ll stop at the Glastonbury location. Thanks. I actually have PH lower left by the PB in my basement. That’s the same stuff right? How much of it should I add to lower PH to start? Then tomorrow when I get home from work I can try the CYA test as well. Then, tomorrow night I can try the...