Recent content by orthopod

It looks like the vent tube extends way past the intake and exhaust ports of the 2 heat exchangers. I'm going to get a flexible camera and check it out

Thank you. I looked further, and I don't know if water has come up enough to get in the heat exchanger. I will say that the drain tube that was hooked up to the bottom of the exhaust was buried as it was outside the heater and secondly, it was disconnected I was able to stick something up into...

Here are some Picrures

Blower does not fire. Nothing happens at all The hoses look fine. I shorted the blue wires to the AFS (jumped them) and nothing, ads light stays on and blowers don't fire. Maybe because blower doesn't kick in at all I'll recheck these, it's one of the first things I I did ----------- As I...

I am at wit end. I've had 2 Service People comment in the north metro Atlanta area to try and get my ETI400 heater working. Both of them when they showed up said they never worked on an ETI 400. Heater clicks on, fans don't even fire. No gas. silent. The red Light with AFS comes on. It's...

Spent this morning troubleshooting. Followed the serial cable from the panel to the pump closely, and there was some Significant fraying of the serial cable (looks Like a squirrel chewed it. )The outer insulation was chewed, and two of the wires were exposed. When I separated these immediately...

Hi Jim. With the panel in auto mode, the pump displays “pump address 1 DISPLAy not active. This was the first thing I checked right after you posted it. So it looks As if the the automation is talking to the Pump. If I put the panel into service mode, all relays (blower, lights, etc.) work...

Ok we are back, and I bypassed the wireless remote by hardwiring the ScreenLogic interface protocol adapter. I can “see” the panel now on ScreenLogic connect, but still cannot turn on any pumps, lights, etc. The main pump is saying “running schedule” but is not turning on. I can’t manually...